Extrusion Know How
How Much Regrind Can You Handle?
Most extrusion operations generate scrap, and in the case of sheet for thermoforming it can exceed 70% of total output.
Read More
Don't Get Burned by Adapters & Flow Pipes
Does degraded or burned polymer seem to show up when you least expect it?
Read More
Communication Is Key in Designing Blown Film Dies
Over the years I have bought, designed, or helped design quite a number of blown film dies.
Read More
Having Output Problems? Check Your Feed-Port Design
With an extruder, like all other devices, “it can’t come out unless it goes in first.” That’s the first thing I remember when I am asked to figure out why an extruder is performing below expectations.
Read More
Extrusion Know-How: The Whys & Hows (& Ifs) of Vented Extruders
Vented or two-stage screws only make sense when volatiles must be removed in order to make a satisfactory product.
Read More
Extrusion Know-How: Proper Alignment Saves Wear & Tear ... or Worse
Is extruder alignment important?
Read More
How Much Horsepower Do You Need?
Most extrusion processors know that in order to boost output you need more power.
Read More