Injection Molding
Bigger ‘Boy’ Debuts At Fakuma
Boy extended the size range of its injection line to 125 metric tons (137.5 U.S. tons), up from a maximum of 100 m.t. (110 U.S.) previously.
Read MoreDigital Manufacturing & Industry 4.0 Highlighted At Fakuma 2018
The “Road to Digitalization” was the theme of Arburg’s exhibit at the Fakuma in Germany.
Read More
Automated Mold-Insert Changing Via Robot for Short Runs
At Fakuma 2018 show in Germany, Engel Austria (U.S. office in York, Pa.) is presenting three premieres in one exhibit.
Read More
Borealis, R&D Startup Collaborate on Low-Cost, High-Performance, Sustainable Single-Use Polyolefin Foam Packaging
Bocatech’s EcoCore molding technology combined with two key Borealis PP grades produces eco-friendly molded products that require less material.
Read More
Up to Snuff on Scientific Molding? Then it’s Time to Mold ‘Systematically’
Scientific molding is centered around learning about key molding principles and theories. The strategic application of those principles and theories is what’s known as systematic molding.
Read More
Christina Keller to Lead Cascade Engineering
Keller takes over for Mark Miller who officially retires at the end of September.
Read More
Paulson Names Karen Paulson As New President
Karen’s new post makes her the first female president of this plastics training company, a company founded by her father, and veteran educator, Donald Paulson.
Read More
Electronic Flow Monitoring Gives Medical Molder a Better Handle on Mold Cooling
Monitoring water flow and temperature in individual channels proves a valuable tool for process validation and troubleshooting.
Read More
