Matthew Naitove - Page 37 of 91 | Plastics Technology

Matthew Naitove Contributing Editor

Contact

sustainability 25 Jun 2019

Ban ‘Single-Use’ Plastics? What If They’re Not ‘Single’ Use?

Today’s high-quality bowls and trays for deli foods and restaurant carry-out should not be branded with the despised “single-use” label.

Automation 20 Jun 2019

How to Make Your Pneumatics ‘Smart’

Emerson’s Avantics Smart Pneumatics Analyzer digitizes the analog pneumatic environment and monitors and analyzes key operating data.

Hot Runners 14 Jun 2019

A Walk Around Incoe’s New Hot-Runner Plant

A private tour—the grand opening of Incoe’s new headquarters plant.

Hot Runners 1 Jun 2019

Water Injection Beats Gas Assist in Lightweighting Car Door Panel

Renault’s conversion from metal-frame construction to plastics prototype switched from gas assist to water injection. Here’s why and how.

Automotive 1 Jun 2019

Placing a Bet on Bioplastics

Steinwall has put years of R&D into learning to design and mold with biopolymers and natural-fiber reinforcements. Now that groundwork is beginning to pay off.

LIM & LSR Molding 20 May 2019

LSR Molders Now Can Tailor Cure Speed, Temperature & Durometer

Elkem’s LSR Select is enabling faster cures at lower temperatures and custom durometer blends. Dosing equipment has caught up with capabilities of this novel material system.

Injection Molding 15 May 2019

Robot & Cobot Makers Are Pairing Up

Sepro adds its Visual controls to UR collaborative robots.

Automotive 1 May 2019

Super-Compact Auxiliary Injection And Intrusion Units

Unusually compact secondary injectors outfit standard presses for multicomponent and sandwich molding.

processor's edge 12 Apr 2019

Injection Overmolding Widens Horizons For Composites Processor

A specialist in thermoset composites since the 1960s, CCP Gransden is a relative newcomer to thermoplastic composites and to injection molding. Its exploration of organosheet overmolding has opened up new potential.