K 2016: Day Two Show Report
Plastics Technology Editorial Director Jim Callari discusses extrusion trends at K 2016 in Düsseldorf, Germany.
All 19 halls of the Düsseldorf Exhibition Centre are fully booked at K 2016 so clearly there's a ton to see at the show. But the Plastics Technology staff has you covered as several of us are here for the entire show run. With Day Two of K 2016 just wrapping up, check out the video below where Plastics Technology Editorial Director Jim Callari discusses some of the trends in extrusion that he's seeing at K 2016.
Related Content
-
How to Effectively Reduce Costs with Smart Auxiliaries Technology
As drying, blending and conveying technologies grow more sophisticated, they offer processors great opportunities to reduce cost through better energy efficiency, smaller equipment footprints, reduced scrap and quicker changeovers. Increased throughput and better utilization of primary processing equipment and manpower are the results.
-
How to Decrease the Extrudate Temperature in Single-Screw Extruders
In many cases, decreasing the discharge temperature will improve product quality and perhaps even boost rate. Here are ways to do it.
-
Extrusion Excellence: This Year's Top Stories
Revisit the year’s most popular articles on extrusion technology and processes, showcasing innovations, best practices, and the trends that captured the plastics processing community’s attention.
