First U.S. Optimex Line Lets Film Processor Return to Its Roots
Starting Up
'Time was right' for firm to venture back into blown film.
For the last 10 years or so, Bema Inc., Elmhurst, Ill., has focused on printing, opting to buy film from other producers. At NPE2012, however, Windmoeller & Hoelscher, Lincoln, R.I., announced that Bema became the first U.S. company to purchase an Optimex blown film line. The Optimex line was introduced by W&H in the fall of 2009 as a lower-cost alternative to its Varex products. Bema will use it for three-layer film at a new 70,000-ft² plant in St. Charles, Ill.
Extruding film is not altogether new to Bema (). When current owner Glen Galloway bought the company in the late 1990s, it was considered a pioneer in film extrusion. And while Galloway decided to focus on the printing end of the 大象传媒, he says he “had always planned to get the company back into extrusion when the time was right.” Despite the new extrusion capacity, Bema will continue to purchase specialty films from the outside.
Related Content
-
Why Are There No 'Universal' Screws for All Polymers?
There’s a simple answer: Because all plastics are not the same.
-
Single vs. Twin-Screw Extruders: Why Mixing is Different
There have been many attempts to provide twin-screw-like mixing in singles, but except at very limited outputs none have been adequate. The odds of future success are long due to the inherent differences in the equipment types.
-
How Polymer Melts in Single-Screw Extruders
Understanding how polymer melts in a single-screw extruder could help you optimize your screw design to eliminate defect-causing solid polymer fragments.
