Engel Establishes New Unit for Project Planning of Composites Systems
Engel adds new commercial sub-division to design and sell composite machinery systems, now separate from its composites R&D unit.
Engel Austria (U.S. office in York, Pa.) has created a new sub-division to support customers in project planning and commercial launch of production systems for fiber-reinforced plastic
composites. Previously, this activity was part of an Engel R&D unit, the Center for Lightweight Composite Technologies. But the increasing demand for integrated lightweight construction solutions requires a separation of the actual project 大象传媒 from development work, states Dr. Christoph Steger, chief officer of the Engel Group.
The new Engel Composite Systems sub-division is located in St. Valentin, Austria, as is the Center for Lightweight Composite Technologies. Engel Composite Systems will be an interface for customers between the composites R&D center, the 大象传媒 units, and the automation division. Engel is exploring a wide variety of composites technologies, including HP-RTM, SMC, injection overmolding of thermoplastic fabric and tapes, and in-situ polymerization of nylon from Caprolactam (T-RTM).
Related Content
-
A Systematic Approach to Process Development
The path to a no-baby-sitting injection molding process is paved with data and can be found by following certain steps.
-
Injection Molding: Focus on these Seven Areas to Set a Preventive Maintenance Schedule
Performing fundamental maintenance inspections frequently assures press longevity and process stability. Here’s a checklist to help you stay on top of seven key systems.
-
Know Your Options in Injection Machine Nozzles
Improvements in nozzle design in recent years overcome some of the limitations of previous filter, mixing, and shut-off nozzles.